I have continued to print the various parts for the prosthetic hand. I have solved some of the issues I was having in terms of parts failing mid-print. I have experimented more with trying the hinges including printing a mold and attempting to cast the hinges out of flexible silicone sealant. This did not work too well as the hand had to be printed as 70% of its intended size which resulted in the hinges/joints being too small to the point that they would get stuck in the mold. The silicone also does not have enough restoring force alone to return the fingers to their original position. I have decided to devote my time to finishing the rest of the device first, and, as I said in my previous post, The current make-shift method is sufficient. The mold, however, is pictured below.
I have printed a prototype for the ring controller. I ran into some problems scaling the part between applications, but eventually I overcame this. I am also figuring out how large the tolerance must be to fit all of the parts securely in the ring while not making it too bulky and uncomfortable to wear. I plan on printing the next iteration of the controller soon but the current one is pictured below.
Moulds and Ring Controller Prosthetic Hand in progress
I have decided that for the purposes of this process it is not necessary to implement wireless control between the controller and the hand. This is something that can definitely be done in later versions of the project; however, for the sake of competition, and taking into account that I would have to spend time learning about how to implement the wireless control, I have decided to hard wire the controller to the hand unless I have time at the end to do otherwise.
I have started to think about how the rest of the electronics including the micro-controller, the servos, and the battery pack ...etc would be housed in the device. I have thought about placing them in some sort of wearable (possible a bracelet) on the controller hand or on the outside of the prosthetic temporarily because in later versions the technology could be integrated inside the hand design. I figured that since I am still in the prototyping phase, it makes sense to have the electronics easily accessible in case of failure or need for modification.
To Do:
I have decided to use a button as the primary sensor due to its low level of difficulty for the user and fairly reliable ability to not be activated by accident. I am currently designing the next ring controller to house the specific micro button that I have selected and plan on integrating them soon.
Once the controller is completed and the rest of the parts for the hand are printed, I still have to integrate the control system with the hand and servos into one system. Finally, I am still figuring out an interface that would allow the user to change the function of the hand easily. I have decided that the primary function will be a simple clasp and release of all the fingers simultaneously as this seems the most intuitively useful function. I have also thought about the idea of having a built in hardware toggle capability for the controller to switch functions without an external interface. This would allow for a faster switch for the user, even if it was just toggling between a few preselected functions that are more useful for the user. I am still confident that the fundamentals of this project will be completed on time.
No comments:
Post a Comment