I have begun 3d printing the prosthetic hang out of basic PLA and attaching the joints together. I ran into trouble creating the hinges as they are meant to be printed out of a flexible filament that would allow the fingers to clasp when the force is applied to the string, but snap back into place when the force is released. I have temporarily attached the fingers to stabilize them with a somewhat flexible material and have secured rubber bands on the back of each joint to restore the fingers to the open position. For the purposes of this project, I think this solution is more than satisfactory as the hand will still work. If I have more time in the end I may design hinges. The current progress is shown in the picture below.
I have prototyped a basic ring controller device using a rubber band and a button in order to test the practicality of the idea. It is comfortable enough to wear, and it does not inhibit mobility of the controlling hand. The basic prototype for the controller is also shown in the image to the left.
I have setup some basic code to turn the servos that will pull on the tendons/strings that will contract the fingers. The amount of rotation for each servo will need to be calibrated precisely later after they are mounted and permanently connected.
I have been running into some trouble with some of the parts failing during printing and am trying to generate better support structures and increase contact with the plate in order to compensate.
Still to do:
Along with printing the remaining parts for the hand, I also have to design and print the ring controller in a more finalized fashion. I am still thinking about which sensor would work best in this application to control the hand. Some limitations are that the sensor must be very small such that it can fit in a ring/controller between the fingers. Another is that the sensor must be reliable and easy to operate for any user. For example, I have thought about using an FSR (Force Sensitive Resistor); however, I am worried that it the threshold setting for force applied may be too specific and that this value could also differ depending on the user. Once the controller is completed, I have to integrate it with the hand and servos into one system. Finally, I will work on an interface that would allow the user to change the function of the hand easily. I am still confident that the fundamentals of this project will be completed on time.
No comments:
Post a Comment